ultrasonic Fuel Level Sensor DF520
- weight:No parameters
- Brand :ultrasonic Fuel Level Sensor
- Model: DF520
The DF520 is non-touch ultrasonic level sensor, which is applicable for fleet fuel management for generators, engine fuel tank, fuel shipping tank, or construction engine fuel tank
The DF520 is non-touch ultrasonic level sensor, which is applicable for fleet fuel management for generators, engine fuel tank, fuel shipping tank, or construction engine fuel tank. It works for kinds of tank, aluminium alloy, plastic, iron, stainless steel and etc.
For the standard version, it is one type of ultrasonic level sensor which measure the liquid level without drilling hole on container. The resolution is 1mm or 0.1%FS (the bigger value). The measurement ranges from 0-2 meters.
The standard version work for up to 3mm thickness tank. If your tank thickness is more than 3mm, you can try the enhanced version DF521, which can work for 10mm thickness tank, such as construction machine and etc.
For the DF520/520, there is wireless option available. It is integrated with GPRS+GPS (or WCDMA+GPS), so it can upload data to server directly. Also It supports to upload data to third party IOT platform, such as Thingspeak™.
It is opened for customized design (OEM/ODM) on hardware or software.
Notes: The brand name Thingspeak is owned by Thingspeak company.
Engine tank for truck;
Engine tank for off road machine;
Storage tank on ground;
50mm (0-50mm maybe not be read out successfully)
1mm or 0.1%FS, the bigger one
3mm or 0.3%FS, the bigger one
120mA@12VDC (GPRS data upload), 75ma@12VDC (other time)
GSM/GPRS quad band (850/900/1800/1900MHz), or
WCDMA/UMTS/HSDPA 900/2100MHZ or 850/1900MHZ
Dingtek / Thingspeak/ ModBus RTU/Customized
-40 ~ 85℃
Diesel,gasoline, water, and other liquid
Transducer stick to tank bottom by glue and tape.
Controller box stick to open sky position by tape.
Optional tool for installation to show the liquid level.
Transducer ø30, Controller box 80*78*30mm
RS232 Rx, connect with pc RS232 Tx; or RS485 B
RS232 Tx, connect with pc RS232 Rx; or
0-5V or 4-20ma
Notes: There is label on sensor body for pin definition, please act as the label shows.
Drive ultrasonic transducer and upload signal
Transducer attached to bottom of container
Fasten transducer and cable
Clean the coating of installation point
Put between the transducer and container While finding the installation point
Put between transducer and container for real installation after installation point found. Applicable for aluminium alloy, steel, plastic tank. Recommend one component RTV Silicon Adhesive 703 or Loctite 380.
Tool for installation.
Test of RS485 version DF520
DF520 Installation Step -1: Introduction of Part Lists
DF520 Installation Step 0: Preparation
DF520 Installation Step 1:Transducer Positioning,Wiring,Fastening
DF520 Installation Step 2: Transducer Fixing, Fastening
DF520 Installation Step 3: Wiring Routing
Installation of transducer with RTV one component silicon
DF520 Adhensive Glue Introduction